Gerber 30-000363 Applegate-Fairbairn Combat Folder Knife, 15th Anniversary, Limited Edition

Gerber Knives – Applegate-Fairbairn – 15th Anniversary Combat Folder Linerlock Knife with Grooved Green Micarta Handles. Model: G0363. 5 5/8″ closed linerlock. 4 1/2″ CPM-S30V double bevel blade with partially serrated bottom section and tumbled finish. Dual thumb studs. Blade is etched with Applegate and Fairbairn signatures on the front and 1996-2011 with serial number on back of blade. Features Roto Lock blade locking system. Grooved green micarta handles. Stainless pocket clip. Serialized. Only 1,500 produced. Deluxe walnut tabletop display stand.”

Product Features

  • 1,500 limited edition, laser engraved blade on both sides
  • Green micarta handle, CPM-S30V blade steel, overall length 10.1″, blade length 4.5″
  • Double bevel, only bottom side sharpened fine edge and partial serration blade
  • US cultivated and manufactured solid American walnut stand with engraving
  • Made in the USA

Click Here For More Information

Please follow and like us:

2 Replies to “Gerber 30-000363 Applegate-Fairbairn Combat Folder Knife, 15th Anniversary, Limited Edition”

  1. My son gave me the original which came out in 1997 on a nice plaque so I had to have this one. It is a well-made monster of a knife that is better made than the original now with S30V premium blade steel & a micarta handle. The original had regular steel & a type of plastic handle. Nice display stand as well.

  2. I have to say, for a special edition knife that cost about $175, this was a let down. One of the sides to the handles was sprung outward, and caused a spongy feel between the two halves. I took the knife apart to try to tighten it up, and discovered two disconcerting things:1- The two halves of the handle are held together at the pivot point of the blade. Yes, there is a lanyard hole, but it doesn’t assist in holding the handle together, only from twisting apart. If it did tighten the handle, the gap wouldn’t have been a problem.2- The pivot point of the blade is held at just the right tension with some sort of thread locker (like loc-tite). Taking it apart results in the loss of that goldilocks tension, causing the blade to angle too far left or right and possibly rub when you fold it shut. Do not disassemble this knife! If you must, then be sure to have some thread locker on hand.

Leave a Reply

%d bloggers like this: